Husqvarna - Forum

Hallo...

Do anyone, know if a KTM LC 4 engine will fit in a husky frame and/or what have to be done to make it fit??

Who wants to do such a stupid thing ?

Buy a KTM LC4 frame, transplant the engine in it and then throw away the complete bullshit (best in the deepest ocean you can find) !!!

Ein freundliches

Hej,

nach Dänemark.

Warum willst du sowas zusammenbasteln? Verstehe den Sinn darin nicht.

Zusätzlich wird dir hier im Forum keiner eine vernünftige Antwort darauf geben wollen, da KTM als Feind angesehen wird.

because of danish tax-rules... it's a much cheaper solution.. and more lightweigt than a KTM!

hey !

try to find a another solution than this construktion ! realy !

take a LC4 and make it leighter or so...

I can't just take another motorcycle...if i could I would!!! Even an 10-12 year old KTM is about 6500 euro because of the danish fucked up vehicle tax-rules!!!!

This is why I wan't to use the cheap engine...

dr.-hasenbein hat geschrieben:hey !

try to find a another solution than this construktion ! realy !

take a LC4 and make it leighter or so...

Why?? Yes I know properly would be easier, but...

could you please discribe YOUR problem with Danisch Tax rules ??? may be we find a another solution...

the problem is that the tax is committed to the frame... so I have to use the husky frame

Don't look for another solution .. I'm only asking for advice on how (if possible) to use a KTM engine in a old ('97) TE 610 frame...

Perhaps you should ask Axel Bergfeld from Bergos Engines: www.bergos.de

He is a specialist for husqvarna and ktm an may have the answers you are looking for.

just place the FIN-Plate from you Husky on a KTM-lc4 Motorbike

...and al lots of stickers and decals for a "husqvarna-look-a-like"